Electrolux IK2620BL Benutzerinformation Seite 18

Problem
Temperature cannot be set.
The temperature in the appliance is
too low/too high.
Temperature setting LEDs flash at
the same time.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
8.2 Replacing the lamp
The appliance is equipped with a longlife LED
interior light.
Only service is allowed to replace the lighting
device. Contact your Authorised Service
Centre.
18 ENGLISH
Possible cause
The FastFreeze function is switched
on.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is greater
than 4-5 mm.
The door has been opened often.
The FastFreeze function is switched
on.
There is no cold air circulation in the
appliance.
An error has occurred in measuring
the temperature.
8.3 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Solution
Switch off FastFreeze function man‐
ually, or wait until the function deac‐
tivates automatically to set the tem‐
perature. Refer to "FastFreeze func‐
tion" section.
Refer to "Closing the door" section.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Refer to "FastFreeze function" sec‐
tion.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
"Hints and tips" chapter.
Contact the nearest Authorised
Service Centre. The cooling system
will continue to keep food products
cold, but temperature adjustment
will not be possible.
installation instructions.
gaskets. Contact the Authorised Service
Centre.