Setting Up Power Supply - Bresser Translucidus NV Bedienungsanleitung

8 Setting up power supply

Base unit
1. Remove the battery compartment cover.
2. Insert batteries into the battery compartment. Make
sure that the batteries are correctly aligned (+/- poles).
3. Replace the battery compartment cover.
4. Wait until indoor temperature is displayed on the base
unit.
Wireless sensor
5. Remove the battery compartment cover.
6. Move the CH slider switch to the position for the de-
sired transmission channel (1, 2 or 3). The correspond-
ing channel is shown on the sensor display.
7. Insert batteries into the battery compartment. Make
sure that the batteries are correctly aligned (+/- poles).
8. Replace the battery compartment cover.
Battery replacement
9. Always replace all batteries in the base unit and/or
wireless sensor with a completely new set of the same
type. Proceed as described above.
10. After the battery replacement, press the DOWN button
on the base unit for approx. 3 seconds to reactivate the
wireless connection.
NOTICE! This weather station can be operated with up to 3
wireless sensors. Each connected wireless sensor must be
operated on a different channel. If only one wireless sensor
is connected, it should be operated on channel 1.
11 / 40