Werbung
Verfügbare Sprachen
Verfügbare Sprachen
_________________________________________________________________________________________
3
Description of the clamping device
The KSC has been designed for centric clamping of raw parts and finished workpieces and
can be mounted and dismounted with just a few hand movements.
The force is generated mechanically and the power gear ratio is linear across the whole
clamping range.
A wide range of accessories ensures the versatility of the equipment.
3.1 Function
The KSC is a direct vice with a driven mechanically via a capsuled thread.
The force is generated directly in a linear manner, without a force amplifier.
The clamping forces depend on the torque.
Both jaws and carriages close respectively open synchronously and are symmetrical with
respect to the position holes in the tool body.
The vice is also suitable for workpiece clamping from the inside to the outside.
4
Operation (standard operation)
4.1 Clamping / aligning
KSC 160 L-280
The basic model includes the following interfaces:
2 x Ø12 H7 positioning holes,centre distance 100 mm, these can be used to position the vice
on grid plates and T-slot tables.
4 x cylinder bores for cap screws M12 or dowel screws Ø12 f7 / M12.
Locating hole Ø25 H6 for the VERO-S quick-change palleting system.
schunk.de
XND.00021.005_A – 10/2018
22
Werbung
