Hama RCR 110 Bedienungsanleitung Seite 4

Warning – Batteries
• When inserting batteries, note the correct polarity (+ and -
markings) and insert the batteries accordingly. Failure to do
so could result in the batteries leaking or exploding.
• Only use batteries (or rechargeable batteries) that match the
speci ed type.
• Before you insert the batteries, clean the battery contacts and
the polar contacts.
• Do not allow children to change batteries without supervision.
• Do not mix old and new batteries or batteries of a different
type or make.
• Remove the batteries from products that are not being used
for an extended period (unless these are being kept ready for
an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a re.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
• Immediately remove and dispose of dead batteries from
the product.
• Avoid storing, charging or using the device in extreme
temperatures and extremely low atmospheric pressure (for
example, at high altitudes).
Risk of electric shock
• Do not open the device or continue to operate it if it becomes
damaged.
• Do not use the product if the
AC adapter, the adapter cable or the mains cable are
damaged.
• Do not attempt to service or repair the product yourself. Leave
any and all service work to quali ed experts.
4. Getting Started
4.1. Inserting the batteries
• Open the battery compartment (14) and remove the contact
breaker. Replace the battery compartment cover.
4.2. Replacing the batteries
• Open the battery compartment (14), remove and properly
dispose of the dead batteries and insert two new AA batteries
with the correct polarity. Replace the battery compartment cover.
4.3. Power supply
Warning
• Only operate the product from a socket that has been
approved for the device. The socket must be installed close to
the product and must be easily accessible.
• Disconnect the product from the power supply using the On/
Off switch – if this is not available, unplug the power cord
from the socket.
• If using a multi-socket power strip, make sure that the total
power consumption of all connected devices does not exceed
the power strip's maximum throughput rating.
• If you will not be using the product for a prolonged period,
disconnect it from mains power.
• First connect the power supply unit to the socket (10) of the
alarm clock and then to an approved mains socket.
Note
• Sustained projection is only possible on mains power.
• However, batteries are required even on mains power, since
the other functions of the alarm clock are powered by the
batteries.
5. Installation
Note – Input
Hold down the p button (3) or the  button (2) to select
values faster.
• Press the MODE button (4) repeatedly to switch between the
following displays:
• Temperature
• Alarm mode 1 (ALM1)
• Alarm mode 2 (ALM2)
• Secondary time
5.1. Automatic date/time setting using the DCF signal
• Once you have inserted the batteries, the display is switched
on, an acoustic signal sounds and the alarm clock automatically
starts searching for a DCF radio signal. During the search, the
radio icon will ash.
• When the wireless signal is received, the date and time are
automatically set.
• The search for the DCF signal takes about 7 minutes.
Note – Time settings
• If, during initial setup of the device, no DCF radio signal is
received within the rst few minutes, the search is aborted.
The radio icon (6) will go out.
• If there are reception problems, we recommend leaving the
clock to sit overnight, since interference is generally less
at night.
• In the meantime, you can start a manual search for the DCF
radio signal at another location or you can manually set the
time and date.
• The clock automatically continues to search for the DCF signal
every hour. If the signal is received successfully, the manually
set time and date are overwritten.
3