Einhell Royal MKS 42/45 Bedienungsanleitung Seite 19

Anleitung MKS 42-45 SPK 1
OPERATING INSTRUCTIONS
• ENGINE PRE-START CHECKS
WARNING: Never start or operate the saw
unless the bar and chain are properly
installed.
1. Fill the fuel tank (A) with the correct fuel mix (Fig. 8).
2. Fill the oil tank (B) with the correct chain and bar oil
(Fig. 8).
3. Before you start the engine, make sure that the
chain brake (C) is released.
• STARTING THE ENGINE
1. To start the saw, push the switch (ON/OFF switch)
to the ON (I) position (Fig. 9A) .
2. Pull out the choke (A) to the point where it latches in
place (Fig. 9B).
3. Press the fuel pump (B) 10 times (Fig. 9C).
4. Place the saw on a firm and level surface. Hold the
saw securely with your foot as illustrated. Tug
sharply on the starter 4 times. Watch the chain in
case it runs (Fig. 9D).
NOTE: If the engine sounds as if it wants to start before
the 4th tug, end the tugging of the starter and proceed
as described in the next step.
5. Push in the choke (G) as far it will go (Fig. 9E).
6. Hold the saw securely and tug sharply on the starter
4 times. The engine should start.
7. Let the engine run for 10 seconds to warm up. Press
the trigger (H) and put it into idle (Fig. 9F).
8. If the engine does not start up, repeat the above
steps.
C
A
B
Abb. 8 Abb. 9A
A
Abb. 9B Abb. 9C
G
Abb. 9D Abb. 9E
07.11.2005 8:51 Uhr Seite 19
H
Abb. 9F Abb. 9G
• RESTARTING THE ENGINE WHEN IT IS HOT
1. Make sure that the switch is set to ON .
2. Tug sharply on the starter rope 4 times. The engine
should start.
3. If the engine does not start up, refer to the instruc-
tions in the section: CHECKS TO BE CARRIED
OUT BEFORE STARTING THE ENGINE
• STOPPING THE ENGINE
1. Let go of the throttle lever and wait until the engine
is running in idle mode.
2. Push the STOP switch down to stop the engine (Fig.
9G).
NOTE: To stop the engine in an emergency, activate
the chain brake and push the STOP switch down.
• CHAIN BRAKE OPERATIONAL TEST
Test the chain brake periodically to ensure proper
tion.
Perform a chain brake test prior to initial cutting,
following extensive cutting, and definitely following any
Chain brake service.
TEST CHAIN BRAKE AS FOLLOWS (Fig. 10) :
1. Place saw on a clear, firm, flat surface.
2. Start engine.
3. Grasp the rear handle (A) with your right hand.
4. With your left hand, hold the front handle (B) [not
chain brake lever (C)] firmly.
5. Squeeze the throttle trigger to 1/3 throttle, then
immediately activate the chain brake lever (C).
A
WARNING:
Activate the chain brake slowly
and deliberately. Keep the chain from touching
anything; don t let the saw tip forward.
6. Chain should stop abruptly. When it does,
immediately release the throttle trigger.
B
WARNING: If chain does not stop, turn
engine off and take your unit to the nearest
Talon Authorized Service Center for service.
7. If chain brake functions properly, turn the engine off
and return the chain brake to the DISENGAGED
position.
B
A
C
Abb. 10
GB
func-
19