Einhell Royal MKS 42/45 Bedienungsanleitung Seite 16

Anleitung MKS 42-45 SPK 1
GB
GENERAL INFORMATION
1
2
8
5
9
16
17
18
15
21
19
20
1. Chain bar 10. Fuel pump
2. Saw chain 11. Safety lock
3. Chain tensioning screw 12. Oil tank cap
4. Spark mesh(inside exhaust) 13. Fan housing
5. Chain brake lever / front hand 14. Fuel tank cap
guard 15. Rear handle / bootstrap
6. Front handle 16. Operating switch
7. Starter handle 17. Choke / (carburetor setting)
8. Spark plug 18. Bar fastening nut
9. Air filter cover 19. Throttle lever
Numbers preceding the descriptions correspond with the numbers on preceding page to help you locate the safety
feature.
2 LOW KICKBACK SAW CHAIN helps significantly
reduce kickback, or the intensity of kickback, due to
specially designed depth gauges and guard links.
5 CHAIN BRAKE LEVER / HAND GUARD protects the
operator's left hand in the event it slips off the front
handle while saw is running.
5 CHAIN BRAKE is a safety feature designed to
reduce the possibility of injury due to kickback by
stopping a moving saw chain in milliseconds. It is acti-
vated by the CHAIN BRAKE lever.
16 STOP SWITCH immediately stops the engine when
tripped. Stop switch must be pushed to ON position
to start or restart engine.
11 SAFETY TRIGGER prevents accidental acceleration
of the engine. Throttle trigger (19) cannot be
squeezed unless the safety latch is depressed.
20 CHAIN CATCHER reduces the danger of injury in
the event saw chain breaks or derails during
operation. The chain catcher is designed to intercept
a whipping chain.
16
07.11.2005 8:51 Uhr Seite 16
6
7
4
22
13
12
3
20. Chain catch
21. Chain wheel trim
22. Clutch cover (not shown)
23. Stop claw
24. Chain guard
SAFETY FEATURES
NOTE: Study your saw and be familiar with its parts.
10
11
14
23