Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Quick release fastener
ASSEMBLY TO THE TOWBAR
A Fastening bolt
B Adjustment screw
C Borehole for the padlock
Photo 1
Ensure that the towbar ball is undamaged, clean and free
of grease!
The bolt lever needs to be pulled back; to do this you will need to
pull the fastening bolt outwards and turn it. The pre-assembled
rear carrier is placed on the towbar from above. Hold the carri-
er horizontally with one hand and use your free hand to switch
over the bolt lever. If the rear carrier is still not rmly in place on
the towbar, you will need to move the bolt lever back again and
turn the adjustment screw at the side a little and then secure
again (see photo 2). Then turn the fastening bolt until it clicks
into place (see photo 3). The rear carrier needs to be secured
with the mounted fastening bolt. The supplied padlock should
be used to additionally secure the carrier and also prevents the
carrier from being stolen. The manufacturer and the dealer will
not be liable for damage or injury caused by incorrect assembly
or improper use. The product has been tested with regard to the
safety and attachments and achieved good results even under
extreme conditions. Therefore we can rule out any malfunctions
if the product is assembled properly.
Photo 2
Photo 2
Photo 3
2
A
C
B
A
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0)202 42 92 83 160
B
info@eal-vertrieb.com
www.eal-vertrieb.com
Werbung
