Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Preparation / Installation
– Pencil /marking tool
– Voltage tester
– Cross-tip screwdriver
– Electric drill
– Edge cutter
– Allen hexagon key 8 mm
Prior to installation
Important: Ensure that a qualified electrician, or
a person trained to carry out electrical installations,
performs the electrical installation.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the
light itself, before you install it.
Before installation ensure that the circuit, to
which the light will be connected, is not ener-
gised. To do this, remove the fuse or switch off
the circuit breaker in the fuse box (0 setting).
Use the voltage tester to verify the de-ener-
gised status.
Installation
Model 14109002L:
Unscrew the lamp glass
.
2
Remove the nuts
3
wall plate
and the plastic washers
4
open the connection housing
Use the holes in the connection housing
which are intended for the screws, to mark the
drill holes. Open these holes (if they are not
open) with a pointed object (e.g. screwdriver).
Ensure that that you fasten the connection
housing with the arrow facing upwards (inside
the connection housing).
Now drill the fixing holes (ø approx. 6 mm,
depth approx. 40 mm). Ensure that you do not
damage the electrical supply line.
Now introduce the wall plugs into the drill holes.
Slide the mains connection lead
the cable entry with the membrane
16 GB/IE
from the light body
1
visible at the front of the
, and
11
(see Fig. A).
5
,
5
through
8
.
10
Pull the protective tube
nection lead
.
8
Fasten the connection housing
ing screws included
Connect the connection cable of the light to
the mains connection lead
lustre terminal
, see fig. C.
9
Also ensure that the colour connection of the
wires is correct when connecting (L or
2 = black or brown, N or 1 = blue or white).
Now connect the earth wire (3 = green-yellow)
to the marked earth terminal
Now carefully attach the wall plate
the connection housing
washers
and secure with the two nuts
11
Check for correct fitting.
Insert the bulb
into the socket carefully and
6
tighten it with a ¼ turn clockwise.
Place the lamp glass
and screw it tightly.
2
Be sure the sealing ring
the lamp glass
(see Fig. D).
1
Reinsert the fuse or switch the circuit breaker
back on.
Your light is now ready for use (see fig. E).
Model 14109302L:
Unscrew the light body
housing
by loosening the screws
5
clockwise (Fig. A).
Use the holes in the connection housing
which are intended for the screws, to mark the
drill holes. Ensure that that you fasten the con-
nection housing
5
wards (on the rear of the connection housing).
Now drill the fixing holes (Ø approx. 6 mm,
depth approx. 40 mm). Be sure not to damage
the supply line.
Now introduce the wall plugs into the drill holes.
Open the connection socket
the connection housing
4 screws
anti-clockwise.
20
Remove the cover cap
Pull the protective tube
nection lead
.
8
over the mains con-
16
with the fix-
5
, (see fig. B).
7
by means of the
8
(see fig. C).
over
4
, attach the plastic
5
3
over the light fixture
1
makes contact with
18
from the connection
2
anti-
15
,
5
with the arrow facing up-
on the rear of
17
by unscrewing the
5
.
21
over the mains con-
16
.
Werbung
