Bullerjan Dot Handbuch Seite 22

Directions
Please carefully read this operation guide
prior to the connection of the stove and its
initial commissioning. This will enable you to
avoid errors in the installation and handling
of your Bullerjan dot ®
Please observe the applicable statutory
controls and local rules in addition to this
operation guide.
Heat-producing appliances may only be
commissioned following their acceptance by
the district master chimney sweep.
Any installation, assembly, maintenance and
repair work must be performed by trained
specialised centres. In the event of improper
use of and/or intervention on the device, its
warranty and operating permit shall expire.
Warning: During the handling of the
stove, all surfaces and the controls will
become very hot! This primarily applies to
the window. Always use the furnished
protective globe for the operation of your
Bullerjan dot .
®
The operator must regularly clean the
heat-producing appliance.
22
.
1 Device, Approval, Certificates
1.1 Approval
The Bullerjan dot is tested according to
®
the following norms: DIN EN 13240:2005
and § 15 A ( Austria ).
1.2 Type sign
You will find the counterfeit-proof type sign
( equipped with a hologram ) on the rear panel
of your Bullerjan dot
®
on page 5 is an exact duplicate of the type
sign on your stove. Both type signs include
the stove number of your Bullerjan dot
1.3 Compliance statement
The manufacturer of the Bullerjan dot
company ENERGETEC Gesellschaft für
Energietechnik mbH – hereby states that the
Bullerjan dot fulfills the norm compliance
®
requirements according to DIN EN 13240:2005
and § 15 A ( Austria ) , and that the quality
standards are constantly monitored. The type
test was performed by the RWE Power AG:
FSPS-Wa 1992-EN
. The type sign pasted
® .
– the
®