clage FX Next Gebrauchs- Und Montageanleitung Seite 21

7. How to use
Main control
The e-paper display changes automatically to main screen approx . 15
seconds after activation or operation (fig . B1) .
Display informations (fig. B1)
Pos. Function
Status display, top (
1
perature above setpoint, unit does not heat)
2 User
3 Menu button
4 Temperature display
5 Battery status
6 Status display, bottom (relevant information about the unit)
7 Applications
8 Sensor keys
Temperature display
The scale ring fills up as the temperature setting is increased . When
water is flowing, the ring shows the power consumption . In addition, the
target temperature is displayed in °C in the middle of the display .
Operating lock active; Inlet tem-
Temperature setting
The two middle sensor keys can be used to select the temperature in 1°
or, in the comfort range between 35 and 43°, in 0 . 5 ° increments from 20
to 60 °C . Below 20°C, the symbol
the heating function .
User selection
User profiles can be listed via the left sensor key and then selected via the
respective sensor key under the profile pictures (Fig . B2) . The profiles are
individualised via the main menu .
Applications
Typical applications (preselection bathroom or kitchen via "Settings")
and corresponding temperature profiles can be selected via the right
sensor key (Fig . B3) .
To change the values select an application and set the new temperature .
Than press and hold the sensor key under your profile picture or under
the application symbol for two seconds .
15
appears and the unit switches off
EN