Parkside PDRW 1800 B1 Originalbetriebsanleitung Seite 10

Operation
2-speed gearbox
CAUTION!
► Operate the speed selector switch 2 only
when the appliance is at a standstill. Other-
wise, the appliance could be damaged.
♦ Set the speed selector switch 2 to position "1"
for a lower speed range.
♦ Set the speed selector switch 2 to position "2"
for a higher speed range.
Switching the appliance on/off
Turn on
♦ Push in the safety button 8 and keep it
pushed in.
♦ Press the ON/OFF switch 9 and keep it
pressed in. You can now release the safety
button 8.
Switching off
♦ Release the ON/OFF switch 9.
Setting the speed
♦ Press the + button 6 to increase the speed.
Press the – button 7 to reduce the speed.
♦
Working with the stirrer
♦ Dip the two stirrers 4 into the material you
want to mix at a low speed.
♦ Once both stirrers 4 are completely immersed
in the material, you can increase the speed.
♦ During mixing, move the stirrers 4 through the
mixing container and keep stirring until the
material is thoroughly mixed.
PDRW 1800 B1
Maintenance and cleaning
WARNING! RISK OF INJURY!
Always remove the plug from the
power socket before working on
the power tool.
■ Use a soft, dry cloth to clean the housing.
Never use petrol, solvents or cleaning agents
that can damage plastic.
■ Keep the appliance clean, dry and free from oil
or grease. Do not allow liquids to get into the
paint and mortar mixer.
■ Clean the paint and mortar mixer regularly;
preferably directly after finishing work.
NOTE
► Replacement parts not listed (such as carbon
brushes, switches) can be ordered via our
Service Hotline.
WARNING!
■ If the mains cable requires replacement, this
should be carried out by the manufacturer or
an approved representative to avoid safety
hazards.
GB │ IE │ 7 ■