Cosmo CKR6 Montageanleitung Seite 24

Factory set code is "0001".
Modify the value of the unlocked parameter by pressing buttons
confirmed by pressing the button
ther parameter and repeat the procedure.
exit parameter settings by pressing the button
Change of service and functional parameters must be carried out only by a
properly qualified expert.
Basic parameters :
Para- Function
meter
S1.1 HYDRAULIC
SCHEME
S1.2 CODE FOR UNLO-
CKING THE SER-
VICE SETTINGS
S1.4 ACTUATOR OPE-
NING DIRECTION
S1.5 DISPLAY ORIENTA-
TION
S1.9 ANTI-BLOCK
FUNCTION FOR
PUMP AND VALVE
S1.17 SENSOR T1 CALIB-
RATION
Service manual
By pressing buttons
which you want to modify and press the button
When the number flashes you can modify it by pres-
sing buttons
.
When the correct code is inserted, the controller
unlocks the parameters for editing and returns to the
selected group of parameters.
Return back from unlocking by pressing button
. By pressing buttons
Parameter description
Selection of hydraulic scheme.
This setting enables the change of code which is necessary
to unlock the service settings.
WARNING! Keep new code on a safe place. Without this
code is impossible to change service settings.
Setting of actuator turning direction - valve opening.
Setting of display orientation.
All outputs that haven't been activated in the last week are
activated on Friday at 20:00 for 60 seconds.
Correction of displayed measured temperature for sensor
T1.
and
, and confirm it by pressing button
,
.
24
you mark the number
and . The setting is
you can move to ano-
Setting range Default
value
01 - 04
01
0000 ÷ 9999
0001
0- RIGHT
1- LEFT
0
0 - REGULAR 0°
1 - ROTATED 180°
0
0- OFF
1- ON
0
-5 ÷ 5 K
0
.
.