Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Only use the same type of batteries / recharge-
able batteries. Do not mix used and new
batteries / rechargeable batteries.
Remove the batteries / rechargeable batteries if
the product will not be used for a longer period.
Risk of damage of the product
Only use the specified type of battery / recharge-
able battery!
When inserting ensure the correct polarity!
This is shown inside the battery compartment!
Clean the contacts on the battery and in the
battery compartment before inserting!
Remove exhausted batteries / rechargeable
batteries from the product immediately.
Initial use
Remove all packaging materials before first use.
Inserting / replacing batteries
Slide the battery cover
the arrow and remove it.
Insert the batteries into the battery compart-
ment
while taking the polarity into account
2
(+ and -).
Only use batteries
"Technical Data."
Slide the battery cover
opposite direction to the arrow.
Hint: Make sure that the battery cover
securely locked in place.
Trimming the LED tape
The LED strip can be trimmed.
DANGER TO LIFE BY ELEC-
TRIC SHOCK!
Before doing any work on the LED strip
the batteries
from the battery compartment
3
Choose the desired LED strip length.
Note Ensure that you cut the LED strip at the
right place. The cutting point lies exactly
in the direction of
4
specified in the chapter
3
back on in the
4
4
remove
9
Safety / Initial use / Installing the LED strip
between the plus and minus pole and is marked
with a black line.
Shorten the LED strip
Be sure to cover the open end of the LED strip
with the adhesive strip
Installing the LED strip
Note: Ensure that the installation area is clean,
grease-free and dry. Otherwise the functionality of
the adhesive strip may be impaired.
Choose a suitable installation area (window etc.).
Remove the protective foil from the reverse side
of the LED strip
Stick the LED strip
onto the installation area and press it on firmly.
Remove the protective film from the adhesive
strip
on the reverse side of the battery com-
5
partment
2
Stick the battery compartment
installation surface.
Note: Make sure that the slider
operated.
Ensure that the motion sensor
movement.
Your lamp is now ready to use.
Switching the LED strip on / off
is
If the slider is set to "M" you can manually
switch the LED strip
The motion sensor
Switch the LED strip
ON / OFF button
Motion sensor
The LED strip
is equipped with a motion sensor
9
.
You can activate this motion sensor
2
the slider
to "D" ("Dynamic"). The range of the
1
motion sensor amounts to a maximum of 2 m. The
light switches on for approx. 25 seconds.
The ON / OFF button
using a pair of scissors.
9
before use (see fig. A).
10
.
9
with the adhesive strip
9
.
to the
2
1
can detect
7
on and off.
9
is deactivated.
7
on and off using the
9
.
6
by setting
7
is deactivated.
6
9
can be
.
7
GB/IE
17
Werbung
