Promise Technology FASTTRAK TX2200 Schnellstartanleitung Seite 9

Performance Logical Disk (Array)
Use this setting to create a Striped (RAID 0) logical disk. These logical disks have
no fault tolerance but they do have better read/write performance.
To create a logical disk for best performance, follow these steps:
1. Press the Spacebar to choose Performance under the Optimize Array for
section.
2. Press Ctrl-Y to save the logical disk information.
The window below will appear.
3. If the drives in your logical disk have been used before, press Y for the
Create and Quick Initialize option. Othewise press N to Create only..
4. If you chose to initialize, press Y to verify that you want your disks initialized.
5. Press Esc twice to exit FastBuild and continue booting your computer.
Proceed to Step 5 and install the FastTrak driver.
Security Logical Disk with New Drives
Use this setting to create a Mirrored (RAID 1) logical disk with two new disk
drives. If one of the drives has data on it, follow the Creating a Security Logical
Disk with an Existing Data Drive procedure on the next page.
Do you want to do quick initialize
or create only? (Yes/No)
Y - Create and Quick Initialize
N - Create Only
Choose Quick Initialize will delete
any existing data on your hard disks.
Y - Continue, Others - Cancel
Before you can use your new logical disk, you must partition and
format the logical disk using your PC's operating system.
Step 4: Create Your Logical Disk
Note
9