Promise Technology FASTTRAK TX2200 Schnellstartanleitung Seite 7

FastTrak TX4300 Serial ATA
RAID Controller card
4. Attach the Y-cable power splitters to your Serial ATA disk drives.
If you are using a Promise SuperSwap 1100 or 4100 enclosure in your PC:
• Connect the power cables to the SuperSwap enclosure.
• Attach a SMBus cable from the Management Connector on the
FastTrak card to the Management Connector on the first enclosure
These actions are described in Chapter 2 of the SuperSwap User Manual.
Step 4: Create Your Logical Disk
You will now use the onboard FastBuild™ BIOS utility to create your logical disk
using the attached drives. There are four different ways to create this logical disk.
You can create a logical disk for:
• Performance (page 9)
• Security, using new disk drives (recommended) (page 9)
Port 1 /
Channel 1
Port 2 /
Channel 2
The FastTrak TX2200/2300 and TX4200/4300 RAID Controllers
are PCI Plug-n-Play (PnP) devices. No changes are necessary in
the Motherboard CMOS Setup for resources or drive types in most
applications.
Individual LED Aggregate LED
Connectors Connectors
FastTrak
TX4300
Note
7
Step 4: Create Your Logical Disk
Management
Connector
Port 3 /
Channel 3
Port 4 /
Channel 4