Herunterladen Diese Seite drucken

HomeMatic HmIP-SCI Montage- Und Bedienungsanleitung Seite 35

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Once the batteries have been inserted, the device will
perform a self-test (approx. 2 seconds). Afterwards, ini-
tialisation is carried out. The LED test display will indicate
that initialisation is complete by lighting up orange and
green.
Never recharge standard batteries. Do not throw
the batteries into a fire. Do not expose batteries
to excessive heat. Do not short-circuit batteries.
Doing so will present a risk of explosion.
Used batteries should not be disposed of with
regular domestic waste! Instead, take them to
your local battery disposal point.
7
Troubleshooting
7.1
Weak batteries
Provided that the voltage value permits it, the device will
remain ready for operation also if the battery voltage is
low. Depending on the particular load, it may be possible
to send transmissions again repeatedly, once the batter-
ies have been allowed a brief recovery period.
If the voltage drops too far during transmission, this will be
displayed on the device or via the Homematic IP app (see
„7.4 Error codes and flashing sequences" on page 37).
In this case, replace the empty batteries by two new bat-
teries (see „6 Replacing batteries" on page 34).
Troubleshooting
35

Werbung

loading