Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Replacing batteries
•
Connect the connection cables of the desired
device to the terminals (E) of the contact inter-
face according to the connection diagram (see
figure 5).
The cable length of the corresponding connec-
tion cable must not exceed 30 m!
6
Replacing batteries
If an empty battery is displayed via the app or the device
(see „7.4 Error codes and flashing sequences" on page
37), replace the used batteries by two new LR03/mi-
cro/AAA batteries. You must observe the correct battery
polarity.
To replace the batteries of the device, please proceed as
follows:
When mounted, the cover (A) can easily be re-
•
moved from the electronic unit (F) (see figure 6).
•
Remove the empty batteries.
•
Insert two new 1.5 V LR03/micro/batteries into
the battery compartment (C), making sure that
you insert them the right way round (see figure 7).
•
Please pay attention to the flashing signals of the
device LED while inserting the batteries (see „7.4 Er-
ror codes and flashing sequences" on page 37).
•
Reattach the cover.
34
Werbung
