To integrate the contact interface into your system and
enable it to communicate with other Homematic IP de-
vices, you must teach-in the device to your Homemat-
ic IP Access Point first.
To connect the contact interface, please proceed as fol-
lows:
•
Open the Homematic IP app on your smart-
phone.
Select the menu item "Teach-in device".
•
•
Remove the insulation strip from the battery
compartment (C) of the contact interface.
•
Pairing mode remains activated for 3 minutes.
You can manually start the teach-in mode for an-
other 3 minutes by pressing the system button (B)
shortly (see figure 2).
•
Your device will automatically appear in the
Homematic IP app.
•
To confirm, please enter the last four digits of the
device number (SGTIN) in your app or scan the
QR code. Therefore, please see the sticker sup-
plied or attached to the device.
•
Please wait until teach-in is completed.
If teaching-in was successful, the LED (B) lights
•
up green. The device is now ready for use.
•
If the LED lights up red, please try again.
Start-up
31