Ramsey Winch PATRIOT PROFILE 6000 Betriebshandbuch Seite 8

Troubleshooting Guide
Condition
MOTOR RUNS IN ONLY
ONE DIRECTION
MOTOR RUNS
EXTREMELY HOT
MOTOR RUNS, BUT
WITH INSUFFICIENT
POWER, OR WITH LOW
LINE SPEED.
MOTOR RUNS, BUT
DRUM DOES NOT TURN
MOTOR WILL NOT
OPERATE
MOTOR WATER
DAMAGED
Possible Cause
Defective or stuck solenoid Jar each solenoid to free contacts. Check each solenoid by
Defective remote control
switch
Long period of operation
Insufficient battery
Bad connection
Insufficient charging
system
Clutch not engaged
Defective or stuck solenoid Jar each solenoid to free contacts. Check each solenoid by
Defective remote control
switch
Defective motor
Loose Connections
Submerged in water or
water from high pressure
car wash
applying 12 volts to coil terminal (it should make an audible
click when energized).
Disengage winch clutch, remove remote control switch plug
from the socket and jump pins at 8 and 4 o'clock. Motor
should run. Jump pins at 8 and 10 o'clock. Motor should run.
Cooling off periods are essential to prevent overheating.
Check battery terminal voltage under load. If 10 volts or less,
replace or parallel another batter to it.
Check battery cable for corrosion; clean and grease.
Replace with larger capacity charging system
If clutch engaged but symptom still exists, it will be necessary
to disassemble winch to determine cause and repair.
applying 12 volts to coil terminal (it should make an audible
click when energized).
Disengage winch clutch, remove remote control switch plug
from the socket and jump pins at 8 and 4 o'clock. Motor
should run. Jump pins at 8 and 10 o'clock. Motor should run.
If solenoids operate, check for voltage at armature post;
replace motor.
Tighten connections on bottom side of hood and on motor.
Allow to drain and dry thoroughly, then run motor without load
in short bursts to dry windings.
6
Correction