Husqvarna Aspire H50-P4A Bedienungsanweisung Seite 14

Note:
The battery does not charge if the battery
temperature is more than 50 °C/122 °F. If the
temperature is more than 50 °C/122 °F, the battery
charger makes the battery become cool before the
battery charges.
To charge the battery
Charge the battery before the first use.
Note:
The battery does not charge if the battery
temperature is more than +35 °C.
1. Connect the power cord for the battery charger in a
grounded mains.
CAUTION:
mains has the correct voltage and
frequency.
2. Put the battery in the battery charger. The battery
is connected to the battery charger when the green
LED flashes. (Fig. 29)
3. The battery is fully charged when the green LED
on the battery charger is on. Charge the battery for
maximum 24 hours.
4. Disconnect the battery charger from the mains.
CAUTION:
cord.
5. Remove the battery from the battery charger.
Battery status LED on the battery charger
The red LED (A) and the green LED (B) on battery
charger show the battery status. Refer to
LED on the product on page 14 .
(Fig. 30)
LED
The green LED flashes
quickly.
The green LED flashes
slowly.
The green LED is on.
The red LED is on.
The red LED flashes
quickly.
14
Make sure that the
Do not pull the power
Battery status
Battery status
The battery is charging.
The battery is 80% charg-
ed.
The battery is fully charg-
ed.
Battery status
Refer to
LED on the product on
page 14 .
Battery status
Refer to
LED on the product on
page 14 .
Battery status LED on the product
When the battery is installed in the product, the LEDs on
the product show the battery status.
(Fig. 31)
LED
LED 1, 2 and 3 are
lit.
LED 1 and 2 are lit.
LED 1 is lit.
LED 1 flashes.
To connect the battery to the product
WARNING:
products of the POWER FOR ALL system
18V.
1. Fully charge the battery.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click. (Fig. 32)
CAUTION:
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
To do before you start the product
1. Examine the work area. Remove objects that can be
thrown out.
2. Examine the cutting attachment. Make sure that the
blades are sharp, and have no cracks and damages.
3. Make sure that the product works correctly. Examine
that all nuts and screws are tight.
4. Make sure that the handle and safety devices are
not damaged and are attached correctly. Do not
operate a product with missing parts or is changed
from its initial specification. Use protective gloves
when it is necessary.
5. Make sure that the covers are not damaged and are
attached correctly, before you operate the product.
To start the product
1. Push the on/off button until the green LED comes
on. (Fig. 33)
2. Push the front handle trigger on the front handle.
(Fig. 34)
3. Push the power trigger. (Fig. 35)
Battery status
Fully charged.
Sufficiently charged
The battery power is low.
The battery is empty. The bat-
tery status indicator flashes.
Charge the battery. Refer to
charge the battery on page 14 .
Only use the battery with
If the battery does not
1888 - 002 - 12.07.2022
To