Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Warning!
These doors are equipped with an automatic closing
system (counterbalance and pneumatic brake). On model
EIS104, During the loading operation, block the door
operating on the specifical lever.
Don't make faster the door running during closing
operation.
Unplug
the unit.
At least once every 30 days remove from the condenser
unit the impurity (dust and deposit) which remain among
the fins of the condenser, obstructing a good circulation
of the air. A dirty condenser reduces the performance of
the equipment, increasing the energy consumption.
Cleaning should be carried out with a soft brush or
preferably with a vacuum cleaner.
For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES: wash with warm water and mild detergent, rinse well and dry with
soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: wash with warm water and mild detergent, rinse well and dry
with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: only use products specifically designed for glass cleaning; It is not advisable to
use ordinary water which can leave a film of calcium on the surface of the glass.
When you place the moving shelves into the tank pay attention to the form of the
special holed conveyer panel: the shelves or the product must not obstruct the
holes. This is necessary to obtain a good air circolation and a uniform temperature
distribution. After plugging, make run the unit for about 1 hour with the lights off,
then load the product: don't place it over the max. load level because the
temperature for good preservation is insufficient.
Any further adjustments on the refrigerator necessarily require the
electric plug absolutely to be removed. Check periodically the
supply cable in order to detect any damage. In case of damage, do
not use the set and not tray to repair it. Call instead qualified
assistance to replace it. In any case, none of the protective elements
(the grill, the carter) must be removed by non qualified staff.
Absolutely avoid using the refrigerator without such protection.
The replacement of neon tubes must be carried out only by an
Authorized Service Center.
EIS 104
PERIODICAL MAINTENANCE
- 9 -
Werbung
