Daikin Altherma FWXT10ABTV3 Installations- Und Bedienungsanleitung Seite 23

Fitting the wall-mounted remote control panel EKWHCTRL1
The wall-mounted EKWHCTRL1 is an electronic thermostat
(fitted with temperature probe optionally remotable in one
of the convectors connected to it) with the possibility of
controlling one or more cooler-convector/cooler-radiators
(up to a maximum of 30).
Install the wall-mounted remote control EKWHCTRL1 away
from doors or windows and sources of heat (heaters,
convectors, stoves, direct sunlight), on internal walls
at a height of about 1.5 m from the floor.
The wall-mounted remote control is already assembled
in the package, therefore before mounting them the
two parts must be disconnected by unhooking the two
protruding notches on their back (A).
Use the base of the control (ref. B in figure) to trace the
fixing point on the wall (use the two opposite holes).
Then proceed with the operations below:
- drill the holes in the wall;
- route the electric wires through the window on the base;
- fix the base of the control to the wall using suitable plugs;
- perform the electrical connection and then close the
control paying attention not to crush the conductors.
A
A
B
EN
23