Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MT400
5
Instructions before installation
I
NOTE
If you do not have sufficient technical knowledge for installing and connecting
components in vehicles, you should have a specialist install the radio remote control in
your vehicle.
Your vehicle should meet the following requirements to be able to open and close it with
MagicTouch:
• 12 V operating voltage
• Central locking system
5.1
Setting the configuration
Clarify the following before installing and programming the system:
• Is the driver's door equipped with its own servo motor for locking?
If no: retrofit a servo motor (e. g. ML-11).
Some manufacturers equip their vehicles with a power-saving central locking system. In these
vehicles, there is no servo motor in the driver's door; there is an electrical switch instead.
• Do the door contacts have a negative or positive charge?
The system must be programmed accordingly, see chapter "Programming MagicTouch" on
page 17.
• Is it permitted by law in your country for the warning system to flash when opening and
closing the central locking system?
The system must be programmed accordingly, see chapter "Programming MagicTouch" on
page 17.
• What should the convenience function control, e. g.:
– the dipped headlights for 10 sec. (coming home function)
In this case, clarify whether the dipped headlights are positively or negatively charged.
– electric power windows and sliding roof.
The system must be connected and set up accordingly, see chapter "Setting up the conveni-
ence function" on page 9.
Is the maximum power of 10 A sufficient?
If no, an additional relay must be used.
EN
Instructions before installation
5
Werbung
