Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating MagicTouch
9
Operating MagicTouch
9.1
Using the remote control
See fig. f
Observe the following instructions when you use MagicTouch:
!
CAUTION! Danger of crushing!
Never allow the electric windows to be closed while they are unattended.
• To ensure the remote control functions properly, a disturbance-free connection between the
hand-held transmitter and the control unit is required.
• Depending on where the control unit is installed, and the transmission power of nearby sources
of interference, the range is up to 20 m.
• Each time the hand-held transmitter is used, it sends a new code (rolling code). For this reason,
the control unit might not recognise the hand-held transmitter immediately if you use the
hand-held transmitter too frequently without the control unit receiving the transmission signal.
In this event, press the hand-held transmitter again another one to three times; after the third
attempt at the latest, the control unit will detect the hand-held transmitter again.
To close the central locking:
➤ Press the "Close" button on the hand-held transmitter.
✓ If the ignition is switched off, the hazard light flashes once for confirmation.
✓ When set: the convenience function is activated.
✓ The interior light is switched off.
✓ The status LED starts flashing.
To open the central locking:
➤ Press the "Open" button on the hand-held transmitter.
✓ If the ignition is switched off, the hazard light flashes twice for confirmation.
✓ In vehicles with a negatively connected door contact: the interior lighting is switched on and
goes out again when the ignition is switched on.
✓ The status LED goes out.
Using the convenience function
If the vehicle is locked, pressing the middle button on the hand-held transmitter activates the
convenience output. Depending on the setting, the convenience output is connected when the
central locking is closed, or by pressing the "Comfort" button.
✓ The hazard lights flash once for confirmation.
18
MT400
EN
Werbung
