Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connecting MT400
7.2
Connecting MT400 to the central locking system
➤ Connect MagicTouch in accordance with the corresponding circuit diagram (for details, see
table chapter "Keys for the circuit diagrams" on page 8):
• Vehicles without a servo motor in the driver's door (driver's door cannot be locked and
unlocked from the passenger's door) or with pressure vacuum central locking without electrical
control cable: fig. 7
In these cases, you will require an additional servo motor, type no. ML-11 for the driver's door.
• Two cables switching from negative to +12 V: fig. 8
• Two +12 V pulse control cables: fig. 9
• Two negative pulse control cables: fig. 0
• One open and negative pulse control cable: fig. a
• One +12 V and negative pulse control cable: fig. b
• Connection to the central locking system ML-44(22): fig. c
I
NOTE
Check whether the indicators flash once upon locking with the remote control.
If they flash twice, you will need to reconnect the grey/yellow cable to pin 12 and the
blue/yellow cable to pin 13 of the control unit.
Keys for the circuit diagrams
No. in fig. 7
to fig. c
1
2
3
8
Designation
Control unit for the vehicle's own central locking system
Control switch (driver's door) for the original central locking system,
central locking closed
Control switch (driver's door) for the original central locking system,
central locking open
MT400
EN
Werbung
