Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating MagicTouch
9.3
Learning or deprogramming the hand-held transmitter
See fig. g
MagicTouch can be operated using up to 10 hand-held transmitters. If a new hand-held transmitter
is to be learned, all other transmitters will have to be paired again.
Proceed as follows for learning a new hand-held transmitter:
To switch to learning mode:
➤ Use a hand-held transmitter to open the vehicle.
➤ Take a seat in the vehicle and leave the door open.
➤ Switch on the ignition.
➤ Press and hold the "comfort" button on a hand-held transmitter already paired.
➤ Switch the ignition off.
➤ Let go of the button.
✓ The status LED and the hazard light flash 10 times, after which they are continually lit.
✓ The system is now in learning mode.
I
NOTE
If you do not press a button within 10 seconds, you will exit the learning mode.
Learning the hand-held transmitter
Learn all the hand-held transmitters which you would like to use during this learning phase. This
also applies for the hand-held transmitters which you have already been using!
➤ Press the "Comfort" button on the hand-held transmitter.
✓ The status LED and the hazard lights go out while the value is being saved.
✓ If the status LED and the hazard lights light up continually again after 2 sec., then the hand-held
transmitter has been paired and you can now learn the next one.
I
NOTE
Only exit learning mode when you have paired all hand-held transmitters which you
wish to use. Hand-held transmitters which you do not learn during this pairing phase
will be automatically deprogrammed from the system. They can only be used again
once they have been relearned.
To exit learning mode:
➤ Switch on the ignition.
Testing the hand-held transmitter
➤ Test the new hand-held transmitter.
If a hand-held transmitter does not function, then they must all be learned again.
20
MT400
EN
Werbung
