Zipper Maschinen ZI-RAM80C Originalbetriebsanleitung Seite 33

13.2 Change engine oil
Change engine oil after the first 20 hours of operation.

Later change it every 200 hours

Best time for engine oil change is approx. 15 minutes after a longer operation, the oil

should be lube warm then.
To drain the old oil, first unfasten the oil drain plug (5) and oil filler dipstick (4) at the

bottom side of the engine assembly.
When draining the old oil, catch it in a bin.

Fill in the new engine oil

13.3 Clean air filter
A polluted air filter makes it very hard to start the engine, it impairs
the engine output and leads to engine malfunctions.
It shortens the engines lifespan and in extreme cases it can ruin
the engine within short time.
So take care to have your air filter kept clean at every time!
To clean the air filter, unfasten the wing nut, remove the air filter
cap, remove the froth mantle and the air filter.
Clean both mechanically (with a brush).
Wipe both thoroughly with a solvent composed of 3 parts diesel and one part motor oil.
Drain motor oil onto the filter, remove excessive motor oil by wringing it out.
Let the engine never run without or with a damaged air filter. Dirt gets so into the engine and
can causing severe engine damage. In this case retailers and manufacturers dissociate from
any warranty.
13.4 Clean spark plug
Remove the spark plug and clean it with a brush from debris. The
contact should be 0,6-0,8mm.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Vibrationsstampfer / Vibrating tamper
NOTE
ZI-RAM80Cite 33
ATTENTION!
Dispose of the old oil in an environmentally
friendly way!
MAINTENANCE
Seite 33