Zipper Maschinen ZI-RAM80C Originalbetriebsanleitung Seite 31

12.2 Proper using
Keep the tamper clean and dry.
Prevent blank hits.
When pushing away the material or when lifting the tamper, let this in no case run with full
throttle.
For optimal control guide bracket as shown.
If the tamper tilts on its side, then lie down as shown and immediately stop the engine (main
switch (3) to "OFF")
To prevent engine damage the tamper should not continue run if he is on the side.
12.2.1 Compacting
Open throttle lever (A) for max. power

Grip the guide bracket with both hands and lead the tamper. Releases in no case the guide

bracken when you are compacting.
Let the tamper move forward itself. Do not apply pressure to the tamper. NEVER try to

move the machine with muscle power forward.
The tamping foot must always occur in a parallel position to the ground (d) to avoid ex-

treme wear on the drive.
A ground with too much moisture can reduce a good compression. Let dry the ground be-

fore compaction something.
A very dry ground swirls when working with the tamper much dust. By adding moisture

the compression can be improved and the maintenance of the air filter can be reduced.
The tamper does not apply to concrete or hard or compacted surfaces. In such cases
the device will jump rather than vibrate causing damage to the tamping foot and
motor.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Vibrationsstampfer / Vibrating tamper
NOTE
NOTE
ZI-RAM80Cite 31
OPERATION
Seite 31