Zipper Maschinen ZI-RAM80C Originalbetriebsanleitung Seite 27

11 SETUP
Check the compactor plate, the air inlet, the muffler and the air filter condition.
Clean them if necessary with a mild solvent.
Do not use paint thinners, petrol or other aggressive chemicals or abrasives for cleaning – they
damage the machine.
11.1 Checks and tasks before first operation
Read, understand, and follow security and setup information
Check all fixing nuts and screws of the machine if tightened well! Not entirely tightened nuts and
screws might become even looser and be lost due to the vibration during operation
A too low oil level leads to engine damages.
Please understand that we do not accept any reclamations on engine damage being
caused by insufficient oil level.
The handling costs of claimed guarantee of defect engines that during service check turn
out to be caused by an insufficient oil level will be charged to the customer entirely.
11.1.1 Check motor oil!
Oil capacity: 0,6 litre
Oil type: SF 15W-40
To check the engine oil level, place the rammer after 10 minutes with the engine off on

secure, level ground.
The filter cap / dipstick from the oil filler neck (4) Remove and wipe clean.

Insert the dipstick into the oil tank, but without tighten the screw and then remove it

again. Check the oil level on the dipstick.
If the oil lever is to low top up the oil SF 15W40 to the edge of the oil filler neck.

ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Vibrationsstampfer / Vibrating tamper
N O T I C E
ATTENTION!
ZI-RAM80Cite 27
SETUP
Seite 27