Zipper Maschinen ZI-RAM80C Originalbetriebsanleitung Seite 28

11.1.2 Check tamper oil
Oil capacity: 0,8 litre
Oil type: SF 15W-40
To check the engine oil level, place the rammer after 10 minutes with the engine off on

secure, level ground
Clean pollution in the area of the sight glass (F).

Check the oil level on sight glass (F). The oil level is OK if the sight glass is full or ¾ full.

If no oil is visible oil must be supplied.
Tilt the tamper until the roll off bar (I) is on the ground.

Loosen the oil screw (F).

Fill in oil

Thigten the oil screw

Place tamper in upright position

11.1.3 Check fuel level
Fuel capacity: 2,7 litre
Fuel type: ROZ 95
 The ZI-RAM80C is being powered with petrol (min. octane 95)
 Pay attention to all security regulations in connection with fuel.
 Remove fuel tank cap, check fuel level by sight.
 If refueling is necessary, pay attention to all security regulations regarding refueling, refu-
el only with filter.
 Refueling only with filter.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Vibrationsstampfer / Vibrating tamper ZI-RAM80Cite 28
SETUP
Seite 28