Zipper Maschinen ZI-RAM80C Originalbetriebsanleitung Seite 29

12 OPERATION
Secure the working area properly before you start to compact.

Never attempt to put the machine into service without having read the security, setup and

operation instruction in this manual and having performed all necessary checks and tasks de-
scribed in the chapter before.
The correct level of humidity is decisive for good compacting results. Humidity is a kind of

lubrication helping to compress particles more together.
Compacting an underground without any humidity is not possible. Too high levels of humidity
make compacting ineffective as well and might cause the machine to stall.
Do not use the tamping rammer at hard undergrounds, frozen underground or rocky under-

ground.
12.1 Start and stop
12.1.1 Cold start
Open fuel cock (K) and (c) entirely

Set Choke lever (8) to „CLOSE"

Bring throttle lever (A) into middle speed position (middle position)

Main switch (3) ON

Recoil start: Grip the handle (7) of the recoil starter, pull it back slightly until you feel re-

sistance, let it roll back, pull it out briskly in one pull entirely.
When the engine started, open the choke (8), adjust throttle (A) in order that the engine

runs idle. Let the engine run in idle for at least some minutes.
To start to compact bring the throttle lever (A) cautious into max. speed position!

ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
Vibrationsstampfer / Vibrating tamper ZI-RAM80Cite 29
OPERATION
Seite 29