Werbung
Verfügbare Sprachen
Verfügbare Sprachen
13.2 Emptying the water separator (Fig. 14)
Emptying the water separator on a sandblaster is an
important step to ensure that the device works effec-
tively and damage is avoided.
Check the water separator regularly and empty it if
necessary. This will ensure that the blasting device
works effectively and will prolong the life of the device.
The device drains itself via the drain valve (20a) when
the water separator is disconnected from the pressure.
1.
Close the main supply line shut-off valve (18).
2.
Release the pressure as described in 10.8.
3.
Press the latching switch and turn the water sep-
arator (20) until it can be removed. Remove the
water separator downwards.
4.
Empty the water separator (20).
5.
Reinsert the water separator (20). Turn it in one
direction until it clicks into place.
14. Repair & ordering spare parts
After any repair or maintenance work, make sure that
all safety-related parts are in place and in perfect con-
dition. All parts which may cause injury must be kept
where they are inaccessible to children or others.
Attention: According to the German Product Liability
Act, no liability is accepted for damage caused by im-
proper repairs or by not using original spare parts.
Such work should be performed by a customer service
centre or an authorised specialist. The same applies to
accessory parts.
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
Important note in the case of repairs:
When returning the device for repair, for safety rea-
sons, please ensure that the blasting media is com-
pletely removed.
14.1 Ordering spare parts
Please provide the following information when order-
ing spare parts:
• Model designation
• Article number
• Type plate data
30 | GB
Spare parts / accessories
Wheels - Article no.:
Nozzle - Article no.:
Manometer - Article no.:
Blasting material discharge tube
- Article no.:
Spray gun - Article no.:
Protective cover - Article no.:
14.2 Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: Sealing ring, blasting hose, nozzle,
protective hood, blasting material discharge pipe
* may not be included in the scope of delivery!
15. Disposal and recycling
15.1 Notes for packaging
15.2 Disposal of sandblasting material
The disposal of sandblasting material depends on the
type of material used for sandblasting and the local
regulations and environmental laws in your region. In
general, however, there are some steps you can follow
to safely dispose of sandblasting materials:
1.
Collect the sandblasting material in suitable con-
tainers such as plastic or metal drums. Avoid using
paper or plastic bags as they can tear and release
the material.
2.
Check the material composition of the sandblast-
ing material. If hazardous materials such as as-
bestos are involved, you should follow the specific
regulations for the disposal of hazardous waste.
3.
Check local regulations and laws for disposal of
sandblasting material. In some areas it may be
necessary to have the sandblasting material col-
lected by an approved disposal company.
4.
Dispose of the sandblasting material in a way that
does not harm the environment. Avoid discarding
the sandblasting material in open areas such as
fields, forests or bodies of water.
www.scheppach.com
5914401002
5914401013
5914401009
5914401006
5914401003
5914401010
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
Werbung
