Herunterladen Diese Seite drucken

Scheppach 5914401967 Originalbetriebsanleitung Seite 25

Mobiles sandstrahlgerät

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Who is not permitted to use the device:
• Children and other people who do are not familiar
with the usage instructions (local stipulations may
specify a minimum age for users).
• People under the influence of alcohol, drugs and
medication, as well as those who are tired or ill.
Safety at the workplace
• Keep your workplace clean and well-lit. Disorgan-
ised or poorly lit work areas can result in accidents.
Act with foresight, observe what is being done and
use common sense when using the device.
• Keep away from children and unauthorised persons.
Carelessness can lead to loss of control over the
product.
• Reinforced hoses should be used in areas particu-
larly vulnerable to damage.
• The pressure line must be connected and discon-
nected with the main supply line shut-off valve
closed.
• Do not interrupt the compressed air supply by
squeezing or bending the lines.
• Gradually increase the air supply to the product to
ensure that it works properly. If the product does
not function properly, disconnect it from the com-
pressed air immediately and contact the manufac-
turer's service department.
• Operate the product outdoors only.
m Warning! Also secure the working area from unau-
thorised access. Only the user is allowed in the area
of the sandblaster. Only persons who have the same
protective equipment as the user may be at a distance
of 2 metres from the device.
Personal safety
• Be careful when operating the product. A moment
of carelessness when working can result in serious
injury.
• The protective clothing and all accessories used
must correspond to the "Personal Protective Equip-
ment" directive.
• Always wear protective goggles, when using the
sandblaster it is recommended to wear a complete
face shield with filter.
• Do not wear loose clothing or jewellery. Keep hair,
clothing and gloves away from moving parts. Loose
clothes, jewellery or long hair can be caught in mov-
ing parts.
• Foreign objects or blown off parts can easily cause
injuries.
• Wear a respirator when working with the product.
Dusts are harmful to health!
• Do not overestimate your abilities. Make sure that
you have a secure footing when working. This gives
you better control over the product in the event of
unexpected situations.
• When working with the device, dust is generated
which may contain substances that are harmful to
health. Operate the product outdoors only. It is rec-
ommended to wear a protective hood.
Safe use of the product
• Before any work, check for general damage or dam-
age to moving parts (breakage of parts and compo-
nents or other conditions that could affect the safe
operation of the product). In the event of damage,
the product must be sent for repair before use.
• Please note that the product's safety systems or
equipment must not be tampered with or deactivat-
ed. Never remove any safety-related parts.
• Only use accessories from the manufacturer. Use
of other accessories may result in injury to the user.
• Always keep the product in good operating condi-
tion.
• Make sure that all nuts, screw-fittings and screws
are securely tightened so that the product is kept in
a safe working condition.
• Do not transport the product by the pressure line or
hang it from the pressure line.
• Maintenance and replacement of hoses, nozzles
etc. should only be carried out with the compressed
air supply switched off and the tank empty.
• Only compressed air shall be used to supply the
product. It is prohibited to use other gases.
• Always hold the transport the product in an upright
position.
• Only blasting material specially designed for sand-
blasting shall be used for the product. It is strictly
prohibited to use ordinary sand!
• Use only blasting material that is absolutely dry.
• When the product is transported or not in use, the
pressure in the pressure vessel should be reduced.
The pressure gauge should show a value of 0.
• The product must always be disconnected from the
compressed air supply during any kind of break in
work.
• This product is only suitable for use on firm, level
and smooth ground. Therefore, always ensure that
you have a firm footing! And that all screw fittings,
especially of the hoses, are sufficiently tightened.
www.scheppach.com
GB | 25

Werbung

loading

Diese Anleitung auch für:

Sbt-80