Cancelling A Programme; Opening The Door - Zanussi ZWF1430 Benutzerinformation

After approximately 15 minutes from
the start of the programme:
• The appliance adjusts
automatically the programme
duration agree with the laundry
load.
• The display shows the new value.
Starting a programme with the Fertig
in/Fini dans option
1. Touch the button
choose the number of hours in which you
want the washing cycle to be finished.
The display shows the number of hours you set
(e.g. ) and the indicator above the button
is on to show that his option is active.
2. Touch the button
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Fertig in/Fini dans option before
you touch the button
touching the button
cancel the Fertig in/Fini dans option.
To cancel the the Fertig in/Fini dans option:
a. Touch the button
appliance to pause. The indicator of
button flashes.
b. Touch the button
above this button goes off.
Touch the button
programme immediately.
Interrupting a programme and changing
the options
You can change only some options before they
operate.
1. Touch .
The indicator of this button flashes.
2. Change the options. If you change any
option the Fertig in/Fini dans option (if set)
will be disabled.
3. Touch again.
The programme continues.
12
again and again to
:
. After
you can only
to set the
until the indicator
again to start the

Cancelling a programme

1. Press the button
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
The appliance does not drain the
water. The water left in a drum can
be used for the next washing cycle.

Opening the door

While a programme (or the
appliance door is locked. The indicator
on.
CAUTION!
If the temperature and level of the
water in the drum are too high, you
cannot open the door.
To open the door during the first minutes
of the cycle (or when the
1. Touch the button
appliance.
2. Wait until the indicator
3. You can open the door.
4. Close the door and touch the button
again. The programme (or the
continues.
At the end of the programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
• In the display comes on.
• The indicator of the button
• The door lock indicator
• You can open the door.
• Remove the laundry from the appliance.
Make sure that the drum is empty.
• Press the button
deactivate the appliance.
• Close the water tap.
• Keep the door and the detergent drawer
ajar, to prevent the mildew and odours.
The washing programme is completed,
but there is water in the drum:
for some seconds to
) operates, the
is
operates) :
to pause the
goes off.
)
goes off.
goes off.
for some seconds to
www.zanussi.com