Starting A Programme With The Finish In Option; Cancelling A Programme; Opening The Lid - Zanussi ZWT 3205 Benutzerinformation

• The indicator of the button
flash and stays on.
• The programme starts, the lid locks, the
indicator
• The drain pump can operate for a short
time at the beginning of the washing
cycle.
After approximately 15 minutes from
the start of the programme:
• The appliance adjusts
automatically the programme
duration agree with the laundry
load.
• The display shows the new value.
Starting a programme with the Finish In
option
1. Touch the button
choose the number of hours in which you
want the washing cycle to be finished.
The display shows the number of hours you set
(e.g. ) and the indicator above the button
is on to show that his option is active.
2. Touch the button
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Finish In option before you touch
the button
button you can only cancel the
Finish In option.
To cancel the the Finish In option:
a. Touch the button
appliance to pause. The indicator of
button flashes.
b. Touch the button
above this button goes off.
Touch the button
programme immediately.
When using liquid detergents in
combination with the Finish In
option, add the liquid detergents
with a dosing ball (supplied by the
detergent's manufacturer).
www.zanussi.com
stops to
is on.
again and again to
:
. After touching the
to set the
until the indicator
again to start the
Interrupting a programme and changing
the options
You can change only some options before they
operate.
1. Touch .
The indicator of this button flashes.
2. Change the options. If you change any
option the Finish In option (if set) will be
disabled.
3. Touch again.
The programme continues.

Cancelling a programme

1. Press the button
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
The appliance does not drain the
water. The water left in a drum can
be used for the next washing cycle.

Opening the lid

While a programme (or the
appliance lid is locked. The indicator
CAUTION!
If the temperature and level of the
water in the drum are too high, you
cannot open the lid.
To open the lid during the first minutes of
the cycle (or when the
1. Touch the button
appliance.
2. Wait a couple of minutes until the indicator
goes off.
3. You can open the lid.
4. Close the lid and touch the button
again. The programme (or the
continues.
At the end of the programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
for some seconds to
) operates, the
is on.
operates) :
to pause the
)
11