Setting A Programme - Zanussi ZWF1430 Benutzerinformation

Detergent compartments
Detergent compartment for wash-
ing phase.
If you use liquid detergent, put it
immediately before you start the
programme.
Compartment for liquid additives
(fabric conditioner, starch).
Flap for powder or liquid detergent.
Liquid or powder detergent
A
B
When you use the liquid detergent:
• Do not use gelatinous or thick
liquid detergents.
• Do not put more liquid then 120
ml.
• Do not set the delay start.
www.zanussi.com
CAUTION!
Do not exceed the
MAX level.
The default position of
the flap is A (powder
detergent).
To use liquid detergent:
1. Remove the drawer.
Push the drawer edge in
the place with the arrow
(PUSH) to remove the
drawer easily.
2. Adjust the flap in
position B.
3. Put back the drawer in
the recess.
A
• Measure out the detergent and the fabric
conditioner.
• Put the detergent and the fabric conditioner
into the compartments.
• Carefully close the detergent drawer.
Activating the appliance
Press and hold for a couple of seconds the
button to activate or deactivate the appliance.
A tune sounds when the appliance is activated.
The appliance performs a start up animation.
The animation quickly shows each washing
programme and the default temperature and
spin settings.
The display shows the word On.

Setting a programme

1. Touch the programme button
programme:
• The indicator of the button
• The display shows the programme
duration.
2. If necessary, change the temperature and
the spin speed or add available options.
When you activate an option, the indicator
of the set option comes on.
If you set something incorrect, the
display shows the message
Starting a programme without the
Fertig in/Fini dans option
Touch the button
• The indicator of the button
flash and stays on.
• The programme starts, the door locks,
the indicator
• The drain pump can operate for a short
time at the beginning of the washing
cycle.
When the flap is in
position B and you want
to use powder detergent:
1. Remove the drawer.
2. Adjust the flap in
position A.
3. Put back the drawer
in the recess.
and set the
flashes.
.
.
stops to
is on.
11