Setting A Programme; Cancelling A Programme - Zanussi ZWT 3206 Benutzerinformation

Detergent compartment for wash-
ing phase.
Compartment for liquid additives
(fabric conditioner, starch).
ACTIVATING THE APPLIANCE
Press and hold for a couple of seconds the Ein/Aus
Marche/Arrêt button to activate or deactivate the
appliance.
A tune sounds when the appliance is activated.
The display shows the word On.

SETTING A PROGRAMME

1. Touch the programme button
programme:
• The indicator of the button
• The display shows the programme duration.
2. If necessary, change the temperature and the
spin speed or add available options. When you
activate an option, the indicator of the set
option comes on.
If you set something incorrect, the
display shows the message
STARTING A PROGRAMME WITHOUT THE
FERTIG IN/ FINI DANS OPTION
Touch the button
• The indicator of the button
flash and stays on.
• The programme starts, the lid locks, the
indicator
• The drain pump can operate for a short time
at the beginning of the washing cycle.
After approximately 15 minutes from
the start of the programme:
• The appliance adjusts automatically
the programme duration agree with
the laundry load.
• The display shows the new value.
STARTING A PROGRAMME WITH THE
FERTIG IN/ FINI DANS OPTION
1. Touch the button
choose the number of hours in which you want
the washing cycle to be finished.
14
CAUTION! Do not
exceed the M level.
and set the
flashes.
.
stops to
is on.
again and again to
The display shows the number of hours you set
(e.g. ) and the indicator above the button
on to show that his option is active.
2. Touch the button
• The door is locked.
• The appliance starts the countdown.
• When the countdown is completed, the
programme starts automatically.
You can cancel or change the set of
the Fertig in/ Fini dans option before
you touch the button
touching the button
cancel the Fertig in/ Fini dans option.
To cancel the the Fertig in/ Fini dans option:
a. Touch the button
to pause. The indicator of button
flashes.
b. Touch the button
above this button goes off.
Touch the button
programme immediately.
When using liquid detergents in
combination with the Fertig in/ Fini
dans option, add the liquid detergents
with a dosing ball (supplied by the
.
detergent's manufacturer).
INTERRUPTING A PROGRAMME AND
CHANGING THE OPTIONS
You can change only some options before they
operate.
1. Touch
The indicator of this button flashes.
2. Change the options. If you change any option
the Fertig in/ Fini dans option (if set) will be
disabled.
3. Touch
The programme continues.

CANCELLING A PROGRAMME

1. Press the button
cancel the programme and to deactivate the
appliance.
2. Press the same button again to activate the
appliance. Now, you can set a new washing
programme.
:
. After
you can only
to set the appliance
until the indicator
again to start the
.
again.
for some seconds to
is