Werbung
Verfügbare Sprachen
Verfügbare Sprachen
menu item
14
If distance compensation is activated, the maximum driven speed is displayed after about one minute of standstill
until the difference in distance has been compensated and the total distance displayed is therefore correct.
menu item
15
If activated, after each stop, the average speed since the e-bike was switched on is displayed for a few seconds.
menu item
16
In stealth mode, the module behaves even more inconspicuously in terms of tuning detection. Depending on the
set speed limit for the motor support, the actual speed driven can be read more easily. The stealth mode remains
active until it is deactivated again via the menu.
Note Stealth Mode:
the smallest possible value, otherwise the displayed speeds will not be correct. This can be done via the Kiox
(Settings → My eBike → Wheel circumference) or the Flow app (Settings → My eBike – manage your eBike settings
→ Wheel circumference). When calibraQng again, this must first be reset to the standard value (factory seTng).
Activating the stealth mode on the module further changes the way the actual speed is displayed, see table under
menu item 12
menu item
17
menu item
18
If the displayed speed is too slow despite correct calibration, this will be adjusted in 1 km/h increments.
menu item
19
If, despite correct calibration, the displayed speed is too fast, this will be adjusted in 1 km/h increments.
menu item
20
The maximum driven speed, which is displayed to compensate for the difference in the distance covered, is reset.
Route compensation on/off
Show verage speed on/off
Stealth Mode on
upon delivery and after each calibration: off
After activating the stealth mode, the wheel circumference must be permanently set to
Stealth Mode off
Speed adjustment +
Speed adjustment –
Reset maximum driven speed
upon delivery and after each calibration: on
upon delivery and after each calibration: off
Werbung
