Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Motor support: When delivered and after each calibration, the motor support is limited to 40
speed limit for the motor support can be freely selected if required (see advanced tuning 3.4).
Speed representation: The speed actually driven remains readable in the standard tuning mode. Up to 22
is displayed 1 to 1, above 22
subtracted from this speed in order to get the correct value.
Examples of speed representation in standard tuning (motor support up to 40
Automatic route compensation: In order to compensate for the difference between the distance actually
covered and the distance displayed, the maximum speed driven is displayed after about one minute of standstill
until the distance has been covered. As soon as the difference has been compensated, the display drops to 0.0
and the e-bike switches itself off after a while. If the e-bike is switched off beforehand, the sIMPLEk saves the
difference and catches up later. As a result, the maximum speed and the distance traveled/total distance are
correctly displayed. In order to counteract the tuning detection, the route compensation should be carried out as
regularly as possible. The route compensation can be deactivated if desired (see advanced tuning 3.4).
it is displayed via the second digit and the decimal place and 20
displayed 24.8
displayed 25.9
displayed 26.4
→ 48 - 20 = 28
→ 59 - 20 = 29
→ 64 - 20 = 44
. However, the
must also be
):
it
Werbung
