Werbung
Verfügbare Sprachen
Verfügbare Sprachen
menu item
12
On delivery and after each calibration, the speed limit will be set at 40kmh. If you wish to adjust the speed limit,
you can do this by following the instructions below.
Please note, by adjusting the speed on the module it will impact how the speed is read on your Kiox or flow app.
Additionally, activating Stealth Mode on the module further alters the how actual speed is displayed, view the
table below
1.
Switch off the e-bike at the 12
2.
Switch on e-bike → [Display shows decreasing speed starting at the currently set speed limit (after the
minimum speed value, the maximum starts again)]
3.
Wait until the desired value is displayed (decimal places are not taken into account) and confirm by
generating at least 2 sensor signals (start driving or turning the rear wheel).
4.
If the e-bike is then switched off directly, the value is saved permanently, otherwise it only remains active
for the current journey
menu item
13
Permanently activated, the tuning mode always starts directly when the e-bike is switched on, otherwise the
tuning mode must be activated via the activation routine each time it is switched on (see 3.2 Tuning mode).
Set motor support speed
menu item and wait 5 seconds after the display is off
Tuningmode permanently on/off
upon delivery and after each calibration: 40
upon delivery and after each calibration: off
Werbung
