Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.2. 1:1-mode
1:1 mode is always started after the e-bike has been operated in tuning mode or 1:1 mode for more than 15 seconds
and switched off. In this mode, the e-bike behaves as if it were not modified.
3.3. Standard tuning
Activating the tuning mode with the Kiox 300 display:
1.
Switch on e-bike → [Kiox stays at 0.0
2.
Switch off the e-bike after it has started up completely, wait at least 5 seconds.
3.
Switch on e-bike → [Kiox shows 10.0
tuningmode is active]
Activating the tuning mode with the LED Remote (no Kiox installed or removed):
1.
Switch on e-bike → [1:1 mode is active]
2.
Switch off after the battery status LEDs on the remote stop flashing and wait at least 5 seconds after
the LEDs are off
3.
Switch on e-bike → [tuningmode is active]
Activation of the tuningmode with the FLOW app
1.
Open the „Ride" window in the FLOW app.
2.
Switch on e-bike → "Open ride screen" appears in the FLOW app → Open the ride screen → [Ride
screen stays at 0.0
3.
Switch off the e-bike and leave the ride screen open, wait at least 5 seconds.
4.
Switch on the e-bike → [Ride screen shows 10.0
constant value), tuningmode is active]
While the e-bike is receiving speedometer signals from the module or speed sensor, it is not
Note FLOW app:
possible to open the speed display of the Flow app (ride screen). To make this possible, simply generate a single
sensor signal by turning the rear wheel (only one turn!). The module then pauses the 10 km/h output for a few
seconds and the FLOW app is released.
, 1:1 mode is active]
with correct calibration (otherwise a different constant value),
, 1:1 mode is active]
:
(consider FLOW app
note)
with correct calibration (otherwise a different
Werbung
