Husqvarna Z560X Bedienungsanweisung Seite 26

Mandrel pulley nuts
Idler pulley nuts
Idler arm bushing nut
Lug nuts
Blade bolts
Spark plug
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your Husqvarna service
agent.
Problem
Engine does not start.
The starter motor does not turn
the engine over.
The engine does not run smooth-
ly.
26
17 ft-lb / 23 Nm
30 ft-lb / 40.6 Nm
70 ft-lb / 95 Nm
75 ft-lb / 102 Nm
90 ft-lb / 122 Nm
16.6 ft-lb / 22.5 Nm
Troubleshooting
Cause
The drive of the blades is engaged. Refer to
page 4 .
Steering controls are not locked in the parking brake position.
The battery is too weak. Refer to
There is dirt in the fuel line.
The shut-off valve of fuel supply is closed or in the incorrect position.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
The battery is too weak. Refer to
The connection at the cable connectors on the battery terminals is bad. Refer to
To clean the battery on page 18 .
A fuse is blown. Refer to
The OPC does not operate correctly. Refer to
The fuel filter or fuel jet is clogged.
The check valve on the fuel tank cap is clogged.
The fuel tank is almost empty.
The spark plug is damaged.
Incorrect fuel mix or fuel type.
There is water in the fuel.
The air filter is clogged.
PTO (Power Take-Off) button on
To charge the battery on page 19 .
To charge the battery on page 19 .
Fuses on page 5 .
Operation conditions on page 9 .
2173 - 002 - 22.08.2023