Herunterladen Diese Seite drucken

Husqvarna Z560X Bedienungsanweisung Seite 20

Vorschau ausblenden Andere Handbücher für Z560X:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 35
1. Connect one end of the red cable to the POSITIVE
battery terminal (+) on the weak battery (A).
B
A
2. Connect the other end of the red cable to the
POSITIVE battery terminal (+) on the fully charged
battery (B).
WARNING:
the ends of the red cable against the
chassis.
3. Connect one end of the black cable to the
NEGATIVE battery terminal (-) on the fully charged
battery (C).
4. Connect the other end of the black cable to a
CHASSIS GROUND (D), away from the fuel tank
and the battery.
To remove the jumper cables
Note:
Remove the jumper cables in the opposite
sequence to how you connect them.
1. Remove the BLACK cable from the chassis.
2. Remove the BLACK cable from the fully charged
battery.
3. Remove the RED cable from the 2 batteries.
To remove and install the battery
1. Fold the seat forward. Refer to
page 12 .
20
C
D
Do not short circuit
To fold the seat on
2. Remove the bolt and the nut from the battery bracket
and remove the battery bracket from the battery.
3. Use 2 wrenches to disconnect the black battery
cable from the negative (–) terminal on the battery.
4. Use 2 wrenches to disconnect the red battery cable
from the positive (+) terminal on the battery.
5. Carefully remove the battery from the product.
6. Install in the opposite sequence.
To adjust the tracking speed
If the product does not move straight forward, the
tracking speed must be adjusted.
WARNING:
speed in an open area without bystanders.
1. Do a check of the tire pressure. Refer to
pressure on page 20 .
2. Turn the tracking controls out until they are flush with
Product overview on page 3 for the
the nuts. Refer to
location of the tracking controls.
3. Start the product.
4. Move the control levers forward fully and operate the
product at full throttle.
5. Turn the tracking control on the right side gradually
until the product starts to move right.
6. Turn the tracking control on the left side gradually
until the product starts to move straight forward.
Tire pressure
Make sure to have the correct tire pressure on all 4 tires.
Technical data on page 30 .
Refer to
Always adjust the tracking
Tire
2173 - 002 - 22.08.2023

Werbung

loading