Cembre HT-TC065 Bedienungsanleitung Seite 4

ENGLISH
2.3) Cutting
Continue operating the moveable handle, the lower blade advances gradually until the cable is
fully cut.
T
he Tool is designed for cuTTing copper
do noT aTTempT To cuT sTeel or
2.4) Blade opening
Press the pressure release lever (48) for the rapid retraction of the ram and subsequent blade (02)
opening.
2.5) Rest setting
After completion of the work, press the release lever (48) to release the oil pressure (refer § 2.4).
3. WARNING
The tool is robust and requires very little daily maintenance.
Compliance with the following points, should help to maintain the optimum performance of the tool:
3.1) Accurate cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be cleaned with a clean cloth, taking care to remove any residual,
especially close to pin and moveable parts.
3.2) Storage
When not in use, the tool should be stored
and transported in the canvas bag, to
prevent damage.
Canvas bag: ref. CVB-010; size 635x170
mm (25x6.7 in.); weight 286 g (0.63 lbs).
3.3) Head rotation
For ease of operation, the tool head can rotate through 320°.
Warning: do not attempt to turn the head if the hydraulic circuit is pressurised.
,
aluminium and Telephone cables
acsr
conducTors
.
CANVAS BAG
:
4