Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2. Press F1 to enter the current character. Press F2 to delete the last character .
3. Press
F4
to finish editing and save the file. Press
operation.
Note: The length of file name is up to 15 characters.
5.43. To Set the Utility Function
Press Utility function key to enter the Utility Menu. You can set the parameters of the
Generator such as: Display Parameter, Counter Parameter, Output Parameter and
System Setting. Press Utility again to exit the Utility Menu.
5.44. To recall wave file from Oscilloscope
This function can read the waveform file with suffix of (*.ota) which is cut from PeakTech®
oscilloscopes and saved to USB device or cut by the software of the oscilloscopes. Then
ARB waveform generators can output the same signal as the cut wave.
Compatible Oscilloscope-models:
PeakTech 1240
PeakTech 1245
* 11/2017 – more models to come
Use one of these oscilloscopes to cut wave:
-
Connect USB device to the oscilloscope.
-
Press
Save
-
Press the H1 button, the Type menu will display at the left of the screen, turn the
"M"-knob to choose
-
Move cursor1 and cursor2 to choose the range of wave to be cut.
Press the "H2"-button, and the input keyboard will pop up. The default name is the
-
current system date. Turn „M"-knob to choose the keys, and press "M"-knob to
input the chosen keys. Choose and press
input and store the file with the current name to USB device.
PeakTech 1255
PeakTech 1260
to call out the save menu.
for type.
Cut Wave
Figure 0-24: Cut Wave
PeakTech 1270
PeakTech 1275
key of the keyboard to end the
Enter
90
F5
to cancel the save
Werbung
