Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.14. To Set the Pulse Width / Duty Cycle
(1) Press F4 button, the chosen menu item is highlighted, the focused parameter is
displayed in Parameter 1. Press F4 to switch between Pulse Width/Duty.
(2) Turn the knob to change the value directly;
or press the number keys to input the desired value and choose the unit.
5.15. To Output Noise Signals
The noise signal which the generator output is white noise. Press
user interface of Noise signal, the Noise waveform parameters can be set by operating the
Noise setting menu on the right.
The parameters of Noise waveform are: Amplitude/High Level, Offset/Low Level. You can
operate the menu by using the menu selection buttons on the right.
To set the Amplitude/High Level, Offset/Low Level, please refer to "To Output Sine
Signals".
Channel
Load
Amplitude
Offset
Figure0-12: Set the Pulse Width of Pulse signal
Noise waveform
Parameter 2
Figure 0-13: The User Interface of Noise Signal
Parameter 3
76
button to call the
Current signal
Setting menu
of Noise signal
Werbung
