Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5.8. To Set the Low Level
Press F3 , confirm whether the "Lo_Level" menu item is highlighted; if not, press
F3 to switch into "Lo_Level". In Parameter 3, a cursor appears under the value of
offset. Use the knob or the number keys to set the desired value.
5.9. To Output Square Signals
Press
button to call the user interface of Square signal, the Square waveform
parameters can be set by operating the Square setting menu on the right.
The parameters of Square waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Duty. You can operate the menu by using the menu selection buttons on
the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to "To
Output Sine Signals" on page 67.
Channel
Load
Amplitude
Offset
Duty cycle
Term Explanation
Duty Cycle:
The percentage that the High Level takes up the whole Period.
Parameter 1
Parameter 2
Figure 0-7: The User Interface of Square Signal
Frequency
Parameter 3
72
Current signal
Setting menu of
Square signal
Werbung
