Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To Turn On/Off Output of Channels
Press CH1 or CH2 to turn on/off output of the corresponding channel. The
indicator will be lighted when the corresponding channel is tuned on.
Channel Copy
(1) In signal output interface, press the knob on the front panel to enter Channel Copy
menu.
(2) Press F1 to select From CH2 To CH1, or press
CH2.
5.2. To set signals
The following describes how to set and output Sine, Square, Ramp, Pulse, Noise,
Arbitrary, DC signals and copy channel.
5.3. To Output Sine Signals
Press
button to call the user interface of Sine signal, the Sine waveform
parameters can be set by operating the Sine setting menu on the right.
The parameters of Sine waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level. You can operate the menu by using the menu selection buttons on the
right.
Channel
Load
Amplitude
Offset
Sine
Parameter 1
Parameter 2
Figure 0-5: The User Interface of Sine Signal
F2 to select From CH1 To
Frequency
Parameter 3
70
Current signal
Setting menu
of Sine signal
Werbung
