Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.3. User Interface
1
Current channel (Only 2 CH devices)
2
Parameter 1, display parameter and edit the focused parameter
3
Current signal type or mode
4
The setting menu of current signal or mode
5
Parameter 3, display parameter and edit the focused parameter
6
Parameter 2, display parameter and edit the focused parameter
7
Display current waveform
8
Offset/low level, depends on the highlighted menu item on the right
9
Amplitude/high level, depends on the highlighted menu item on the right
10
Frequency/period, depends on the highlighted menu item on the right
11
Load, High Z represents high resistance
4.4. General Inspection
After you get a new Waveform Generator, it is recommended that you should make a
check on the instrument according to the following steps:
1.
Check whether there is any damage caused by transportation.
If it is found that the packaging carton or the foamed plastic protection cushion has
suffered serious damage, do not throw it away first till the complete device and its
accessories succeed in the electrical and mechanical property tests.
2.
Check the Accessories
The supplied accessories are described "Appendix A: Enclosure" of this Manual.
You can check whether there is any loss of accessories with reference to this
Figure 0-3 User interface (take Sine for instance)
66
Werbung
