Sony CBK-3620XS Bedienungsanleitung Seite 25

Inspection and
Maintenance
Inspection before shooting
Inspect the unit before shooting to make
sure that the system is operating normally.
Cleaning
Wipe off dirt on the exterior and any
metallic powder created by attachment/
removal using a soft, dry cloth. In extreme
cases, use a cloth moistened in a little
neutral detergent, then wipe dry.
Do not use organic solvents, such as
alcohol or thinners, as these may cause
discoloration or other damage to the finish
of the unit.
Do not clean the unit with an air blower.
Dust and other particles suspended in the
air may enter the unit and cause a
malfunction. Also, refrain from cleaning
with high air pressure equipment, such as
an air duster, as these may damage optical
components.
• Using the unit with dirt or dust adhering
to the connector between the camera
body and sensor block may cause a
failure or malfunction. When storing, use
the supplied protection cap to prevent
dust from adhering to the connector.
• The cable may become twisted and
tangled if coiled in a single loop. Wind the
cable in a figure of eight.
Notes on Device
Connections
• A Sony audio wireless receiver cannot be
used for connecting the CBK-3620XS.
Inspection and Maintenance / Notes on Device Connections
25